Sunday, 18 August 2019
 
Home Page      |Krystallon      |Martechnic      |KWH      |Contact Info
> Exhaust Gas Cleaning
      Limnos Sea Water Scrubbet

KWH
Krystallon PDF Print E-mail

Desulphurization scrubber for marine and power plant applications

Introduction

 

Krystallon has developed the most efficient SO2 scrubber available in the market for marine and power plant applications. P"O’s ferry Pride of Kent installed such a unit in 2005 and has operated multiple thousands hours of uninterrupted operation, without a single incident.

 

The guaranteed emissions reduction performance is well below that required by European marine SOx emissions legislation (2005/33/EC).

Emissions in the stack have been noted as follows:

  • The measurement of SO2 emissions in the exhaust stack indicates >95% removal for operation that involves removing the steam plume from the stack exhaust, and closer to 100% for no deplume requirement.
  • NOx – 5% removal.
  • PM – the current units achieve a reduction over 50% of the Particulate Matter (both primary and secondary). This removal efficiency will be affected by fuel chemistry.
  • System already has passed a detailed Environmental Impact Assessment.

 

The proposal is targeted at a single pilot unit. Krystallon installed this unit at its own cost and risk as a pilot PPC system , to prove:

  • Significant benefits of using our sea water scrubbing technology to remove harmful pollutants from the air and water discharge
  • Emit near zero SOx pollutants yet keep the engines operating on 3.5% high sulphur fuel oil
Limnos Scrubber

Krystallon unit fitted to one of the 2.2MW engine exhausts at the PPC facility in Limnos. This was undertaken at Krystallon’s risk and cost aiming to demonstrate the outstanding environmental performance of the system.

 

Scrubber Benefits

  • By scrubbing one engine, PPC will be able to understand how effective the Krystallon scrubber can treat the exhaust from an engine, and project it to the overall power plant. This would be at no risk or cost to the power plant.
  • Additional to the reduction of SOx emissions, the scrubber makes a significant contribution to eliminating particulate emission – which is very likely to be the subject of the next round of legislation.
  • The scrubber will also act as an effective silencer, as it will be fitted in place of the existing silencer that is frequently corroded and in need of regular overhaul.

 

Fitting scrubbers therefore, effectively "future proofs" the power plant from up–coming legislation on further reducing sulphur content and other legislation on PM. It also, more importantly, enables the power plant to purchase high sulphur fuel oil 3.5% S, which apparently has a dramatic positive effect on the operating and overall fuel costs.

 

Krystallon OEMing this technology believes that this way forward is both the best for the current power plant operation, as well as protecting itself from future more strict legislation. Also, the manufacturer stands 100% behind this technology and guarantees its performance, while has a stated policy of no harm to the environment in all its worldwide operations. This technology is backed by very extensive environmental impact assessment work undertaken over a 2 year time frame and that proves that the technology is an excellent alternative to the use of low sulphur fuel oils.

 

Pilot Unit

 

This unit is designed to treat the engine exhaust from a 2.2MW engine. The corroded silencer removed and replaced with the scrubber vessel, which acts as a very efficient silencer.

 

The system operates by collecting sea water from the engine cooling water system and pumping it into the scrubber system. The water would be collected from the cooling water return line, and would therefore have no effect on the operation of the engine.

 

The wash water would remove the SO2 plus particulates and oils from the engine exhaust and exit the bottom of the scrubber. From there it would be pumped through the Water Treatment Plant, where are removed all the particulates, oils and the miscellaneous residues obtained during scrubber chemical reactions. The cleaned wash water stream is then mixed with more water from the engine cooling system where the alkalinity increases the pH to over 6.5

  

Equipment Specification (Pilot Unit)

Scrubbers Array
Side view of a Krystallon installation similar to Limnos, 2 X 5MW, 3 X 2.2MW

 

The specifications for the various components in the system are as follows:

  • Engine Scrubbers (2.2MW)
    • Number of units –1
    • Space Requirement –2m x 3m
    • Pressure drop –10" w.c. (25mbar)
  • Scrubber Supply Pumps –P100
    • Number of units –1
    • Design capacity of each –110m3/hr
    • Discharge Pressure –3.0bar.g
  • Water Treatment Pumps –P500
    • Number of units –1
    • Design capacity of each –110m3/hr
    • Discharge Pressure –2.0bar.g
  • Pumping Power Requirements
    • Estimated at 25kW maximum
  • Water Treatment Plant –WT500
    • Number of units –1 off MC–10
    • Throughput –110m3/hr
    • Pressure drop –1.5bar.g
  • Caustic Injection System
    • Storage tank 1m3 capacity
    • Positive displacement pump
    • Amount controlled by pH indicator controller
  • Sludge Collection Tank
    • Capacity of 1m3
    • Material of Construction polypropylene
    • Positive displacement transfer pump
  • Exhaust Gas Monitoring
    • Uses high quality in–situ CEM system
  • Water Discharge Monitoring
    • Fluorometer monitoring PAH concentration

 

Performance Targets

 

The operating targets for the subject unit, in PPC at Limnos Power Plant, are listed below. The performance is based on the engine running on 3.5% sulphur fuel and with a maximum power load of 2.2MW:

 

   Performance Targets for installed Unit in PPC at Limnos Power Plant

  • SOx Removal Efficiency – With Deplume >95%
  • SOx Removal Efficiency – Without Deplume >98%
  • Discharge Water Quality <1ppm hydrocarbons, <30ppb PAH

 

Process Design Parameters

 

The system is designed to operate on a single 2.2MW diesel engine using the available water supply for scrubber supply water and dilution of the scrubber discharge. The scrubber is designed for efficient performance with an engine operating at full load on 3.5% Sulphur fuel.

 

Scrubber supply pump is included which add sufficient wash water to the scrubber to ensure adsorption of the SO2 in the engine exhaust gas. After scrubbing the exhaust gas, the wash water is treated in Krystallon’s water treatment package. The scrubber supply pumps also act as a source of reaction water, which is added to the wash water. This generates clean water which will be discharged to the sea.

 

The Water Treatment Plant is designed to remove the suspended particles and entrained oils contained in the water wash stream, using small cyclone separators, or multiclones. The particulates that have been scrubbed out from the engine exhaust are collected in the base of the vessels and are periodically blown down to a Sludge Collection Tank. Caustic is added to maintain the pH in the tank at 7. The particulates settle out in the base of the tank, and the excess clean water is pumped out to sea. The contents in the tank will require removing once the tank starts to fill.

 

An important piece of the overall package is the monitoring equipment supplied for both the water outlet (to measure the cleanliness of the discharge water) and the gas emission to the atmosphere. This equipment uses the very latest in Continuous Emissions Monitoring (CEM) technology with very accurate measurements recorder in a supervisory computer system.

 

Monitored parameters on exhaust and water discharge

  • Exhaust discharge: SO2, SO3
  • Exhaust CEM: CO2, NO, NO2 and Temperature
  • Water Discharge: pH
  • Water discharge uses Fluorometer technology: Temperature and Hydrocarbons (using PAH as surrogate) 
 
     Home Page|     Newsletter|     Contact Info
Address:
Martechnic Navigation LTD
7 Griva Digeni Str., Limassol, Cyprus
Tel. +30 2104227267
E-mail: sales@martechnicltd.com
 

Address:
Martechnic KittiwakeHellas Group
120 Syngrou Ave., 11743 Athens, Greece
Tel. +30 2104227267
E-mail: sales@martechnicltd.com

 
Facebook Twitter News YouTube Google  
Designed by Martechnic KittiwakeHellas Group. All Rights Reserved 2018-2019.